Download or read book Metrological Challenges of Synchrotron Radiation Optics written by and published by . This book was released on 1999 with total page 7 pages. Available in PDF, EPUB and Kindle. Book excerpt: Modern third generation storage rings, require state-of-the-art grazing incidence x-ray optics, in order to monochromate the Synchrotrons Radiation (SR) source photons, and focus them into the experimental stations. Slope error tolerances in the order of 0.5 [mu]Rad RMS, and surface roughness well below 5 Å RMS, are frequently specified for mirrors and gratings exceeding 300 mm in length. Non-contact scanning instruments were developed, in order to characterize SR optical surfaces, of spherical and aspherical shape. Among these, the Long Trace Profiler (LTP), a double pencil slope measuring interferometer, has proved to be particularly reliable, and was adopted by several SR optics metrology laboratories. The ELETTRA soft x-rays and optics metrology laboratory, has operated an LTP since 1992. We review the basic operating principles of this instrument, and some major instrumental and environmental improvements, that were developed in order to detect slope errors lower than 1 [mu]Rad RMS on optical surfaces up to one metre in length. A comparison among measurements made on the same reference flat, by different interferometers (most of them were LTPs) can give some helpful indications in order to optimize the quality of measurement.