Download or read book Nanosecond Pulsed Plasma-assisted Combustion written by Moon Soo Bak and published by . This book was released on 2013 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: In this study, the use of non-equilibrium plasmas is examined as possible methods of active control of combustion. The plasmas investigated here include nanosecond-pulsed repetitive discharges as well as nanosecond-pulsed laser-produced breakdowns. These sources are used to stabilize both premixed and jet-diffusion flames of various fuel types. The use of nanosecond-pulsed repetitive discharges to stabilize lean premixed fuel-air mixtures is found to extend the equivalence ratio for complete combustion to lower values, in some cases, below the so-called lean flammability limits. This extension depends strongly on the pulse repetition frequency or average discharge power. Simulations reveal that a significant production of radicals associated with gas heating is responsible for flame stabilization and this is attributed mainly to a dissociative quenching of electronically excited species by molecular oxygen. In jet diffusion flames, anchoring of the flame-base is best when the discharge plasma is positioned where the local equivalence ratio is between 0.8 and 1.9. Lastly, the discharge plasma source is replaced by laser-induced breakdowns. Two successive laser pulses with a variable time delay are employed to mimic repetitive breakdowns expected from a future high frequency laser source of sufficient power. From studies first carried out in pure air, it is found that the first laser breakdown causes a temporal region virtually transparent to the subsequent laser pulse during the interval from 100 ns to 60 μs. This is attributed to heating by the plasma, reducing the density below threshold levels needed for absorption of a laser pulse. In premixed fuel-air mixtures, the first breakdown induces a second region of transparency during the interval from 100 μs to 2 ms after the pulse due to the heat released by combustion. These findings limit the laser repetition rate to a maximum of 500 Hz when the equivalence ratio is 1. Time-resolved imaging of CH* chemiluminescence reveals flame front merging confirming that flame stabilization can be achieved at these moderate laser repetition rates.